No products in the cart.
These mills allow you to produce chain-sawn lumber and squared timbers without modifying your saw. All include use instructions. For best performance a ripping chain is recommended. Affordable for smaller-scale work the small mill fits saws 20or under and cuts boards from 1/2to 13thick and up to 17wide. Constructed from plated steel and aluminum it is lightweight yet rugged. Maximum cutting width is approximately 3less than the nominal length of the saw bar. Suitable for heavy-duty use the larger Alaskan MKIV mills cut boards from 1/2to 12thick. They are usable with any make of chain saw with bar sizes up to 24″ 30″ 36″ and 48for the largest mill and the width of board milled is limited only by the length of the saw bar used. The main frames are made from 1 1/8square machined extruded aluminum; the chain-saw support posts and clamps are made from 1tubular steel stock welded and plated. Graduated posts and TChandles make adjustments quick and easy. The use of a mill on any saw with a bar less than 16is not recommended. Made in the USA.