No products in the cart.
The Tru-BoostX Boost Controller Gauge delivers all of the features you loved about the original only now with AEMnet for data logging and a big fat internal MAP sensor that can handle boost pressures up to 80 PSI of boost. The Tru-BoostX Boost Controller gauge delivers digital accuracy but with the simplicity of a manual boost controller. All AEM Tru-Boost gauge programming is done using the faceplate buttons and no laptop is required. AEMs specially designed Boost Control Solenoid and all necessary hardware is included. C Program two boost modes for different levels of performance up to 80PSIg internal MAP sensor and program a time-based scramble boost setting that is controlled using a switched input. You can also turn off the controller and use the gauge as a display. Ideal for reducing boost spikes and improving spool up. CSee your boost in the units you prefer and scale the 24 outer LEDs to match your peak boost levels for the perfect sweeping motion. Set the 24 green outer LEDs to flash based on boost pressure so you are alerted to an overboost condition. A ground output is included for triggering an optional LED warning light. Select the B button to see peak boost level and clear the value using the menu. Protects your engine from an overboost condition by shutting the boost control solenoid off until it is reactivated by you through the buttons on the faceplate. Alerts you to a fault if the boost control solenoid is shorted or disconnected so you are never left guessing whether the Tru-BoostX is operational. Outputting channels over AEMnet provides so much more than just boost pressure! Send 13 channels of data over a 2-wire connection including boost pressure peak boost boost target boost scramble duty overboost status wastegate crack pressure boost control solenoid status and more.