No products in the cart.
Remote Car Battery Disconnect System: When you leave the car for a long time the battery is still working. This product remotely controls your car’s power system eliminating any drain on the battery when the vehicle is not in use and avoiding leakage Compatible with Various Models: The battery shut off switch is suitable for 12V DC power vehicles Fit for Ford Chevrolet GMC Dodge and most cars trucks RVs vans trailers and more The liquid crystal display detects the battery voltage at all times. When the battery voltage is lower than 12 the switch is automatically turned off. When the battery voltage is higher than 135 the remote control stops working Easier to Disconnect the Power: This remote control electromagnetic switch moves the trigger from under the hood to your hand so you don’t need to open the hood every time to close or power on just press the remote button more convenient to use Easy to Install: The remote control battery switch adopts the method of negative connection. Compared with other types of products the installation and use are simpler and the performance is more stable. It has a recommended wrench for installation. You only need to install and fix it according to the instructions Product Specifications Working voltage: DC 8-16V Rated voltage: DC 12V Power-off current: 0.002A Product weight: 300g Whole machine working current: 0.25A Operating temperature range: -40C-90C Note: 1. When the driving voltage is lower than 13.2v and the remote control mode of the driving state do not power off at will so as to avoid vehicle failure 2. The size of the negative pole head is 9-13mm. Not suitable for small pile heads. NOT fit for Alto Fit Liwei Sylphy New Sunshine Tiida and Chevrolet Lechi 08. 3. If the original car has a secondary battery or it needs to be decoded matched programmed etc. it is not recommended to install it. Installation Steps: 1. Before installation turn off the vehicle. 2. Remove the negative pole of the battery and fix the manual switch on the negative pole of the battery. 3. Connect the negative wire to the negative terminal of the battery and fix it on the bolted end of the installed manual switch. 4. The device’s positive line is connected to the battery’s positive terminal. 5. Use 3M glue to fix the product.