No products in the cart.
Make almost anything out of piping by keeping our benchtop tubing notcher in your toolkit. Constructed from solid steel this easy-to-use tube notcher is built to create accurate notches time after time. Its designed to notch tubing from -inch to 3-inch in diameter which means you can build go-carts a full roll cage for a race car a custom exhaust on your hot rod and much more. Our pipe notcher does all this while fitting conveniently on most workbenches and sliding into a toolbox drawer when youre done. Use any -inch hand drill to power the Eastwood Professional Tubing Notcher. The cutting angle is adjustable up to 50 degrees with the loosening of one bolt giving you countless possibilities. Adjust to your desired angle with one hand and lock down the bearing block with your other. This adjustment method is easier than other designs on the market. Mount it in a vise or on a bench top for stable operation. Specifications Notch tubing from 3/4 In to 3 In tubing 90 to 140 degrees angles Roller bearings and a 25mm steel shaft Use any 1/2 In hand drill to power Contents 1 Tubing Notcher Hole Saws not included