No products in the cart.
Unquestionably the most important fasteners in any engine are the connecting rod bolts as they hold the key to the entire rotating assembly. A broken bolt will lead to catastrophic engine failure. As you can imagine the most critical joint is where the connecting rod halves mate. The rod bolts must support the primary tension loads caused by each rotation or cycle of the crankshaft. When the crank rotates the big end of the connecting rod essentially becomes oval-shaped and the rod bolts bend. As the crankshaft continues to rotate the rod becomes round again. With alternating tension loads and cyclic bending of the bolts it is very important to install fasteners that are able to exert a clamping force greater than the load imposed upon the joint tension. In addition to utilizing a rod bolt with sufficient strength to withstand the tremendous cyclical strains placed upon it it is absolutely imperative that the bolts be properly tightened. The preferred method of monitoring the correct amount of tension is through use of a stretch gauge. This is far more accurate than using a torque wrench. Moreover through subsequently checking the rod bolts length at teardowns it is possible to determine if it has been stressed beyond safe limits and must be replaced. A premium grade 8740 alloy chrome moly steel is used to manufacture ARP High Performance connecting rod bolts. This material is heat-treated to provide a tensile strength in the 200000 psi range which is substantially stronger than the OEM bolts. Cycle testing shows ARP High Performance rod bolts to be nearly five times more reliable than stock bolts.