Eastwood Master Blaster Dual Abrasive Soda Blaster

Eastwood Master Blaster Dual Soda and Abrasive Blaster lets you switch on-the-fly between soda and abrasive media or a combination of both! Use soda blast supplies to remove coatings on delicate substrates such as fiberglass chrome or stainless then easily switch on-the-fly to harsher abrasives such as crushed glass glass bead or aluminum oxide to blast through heavy scale rust or multiple coatings. It’s a must-have tool for restoration and maintenance shops where rust and paint removal are issues on multiple surfaces such as fiberglass steel aluminum etc. Each of the fully welded powder-coated tanks holds 100 lbs. of abrasive media 75 lbs. of soda and works on as little as 10 cfm at 90 psi. 8-ft.-long heavy-wall blast hose. Use with 80 grit or finer blast media. Use of Walnut shell media is not recommended. Specifications Tank Volume 2X: 10 gallons / 100 lbs. abrasive or 75 lbs. of soda media Hose Length: 8 ft. x 1/2 inch i.d. Working Pressure: 60-125 psi Air Consumption: 6-25 cfm Weight: 80lbs. Contents 1 Dual Tank Assembly pre-assembled with: Lower Frame and Axle Assembly; Inlet Manifold Assembly 1 Upper Loop Frame 2 Wheels 1 Front Support Loop 1 Blast Discharge Nozzle Dead Man Valvew/ 3.5mm Nozzle #12113 installed 1 2mm Nozzle 1 2.5mm Nozzle 1 3.0mm Nozzle 1 Deadman Valve Sealing Pad 1 Blast Hose Assembly with 2-1 Manifold 1 Moisture Trap / Inlet Valve 1 Pressure Gauge 1 Face Shield 1 Funnel 1 Tefl on Tape 4 Washers 4 Cotter Pins 4 1/2 inch Long Socket Head Cap Screws 1 Hex Wrench