No products in the cart.
All RaceQuip harness systems are constructed using drop-forged steel hardware for ultimate strength and reduced weight. All hardware is cadmium plated for added protection. RaceQuip uses only 3inch premium nylon webbing and all belts are box-x pattern sewn to ensure uniform stitch length and strength. Belts and hardware are routinely tested to verify compliance with SFI 16.1 standards. All RaceQuip harness sets feature a latch and link system to retain the belts. The latch and link system is distinguished by a pivoting hammer called a Duckbill which locks all of the belts into place by snapping down into a detent. Both shoulder belts and the sub-belt are hooked over the link; the link is inserted into the latch; the Duckbill is then brought down into and over the link securely holding all of the pieces in place. Harness systems come as a pull down design. This means that the lap belts must be pulled down and away from the center latch and link mechanism to tighten. All necessary mounting hardware is included with each belt set. Since RaceQuip belts are double adjustable lengths are easily adjusted on either end for ease of installation. Using the included three bar slide you can mount the belts by either wrapping them around a rollbar or by bolting them in place. Snap-in ends and eyebolts are sold separately if user wishes to install belts in that manner.