Rockler Perfect Fit Dado Jig for The Router

With just two passes along a straight edge guide the Perfect Fit Dado Jig lets you rout precise dados and grooves at any increment from 1/4” to 1” wide. Since it uses a scrap of your actual material for setup the fit is spot-on every time. Just rout the first shoulder with the jig in the ”closed” position then rout the second shoulder with the jig in the ”open” position. The result is a tailor-cut dado that fits like no other. Once the jig is set the stops make it easy to return to the ”open” position so you can machine as many dados as you like for that thickness. No need to buy undersized plywood bits or bits for other odd thicknesses your dados can fit any thickness within the range 19/64” for example using standard 1/4” 3/8” or 1/2” straight bits. Not only do you get easy operation and a perfect fit you also get an integral dust port that lets you hoover up the mess before it ever hits the floor. Features: Perfect for plywood that’s thinner than the nominal thickness and for lumber that’s been planed to a non-standard thickness – Uses a scrap of your actual material to set cutting widths for a precision fit – Built-in dust port provides point source dust collection – Knurled knobs act as stops making it easy to return to the ”open” position for cutting multiple dados of the same width – Cuts dadoes from 1/4” to 1” wide – Made from durable smooth-sliding glass-reinforced plastic – Not for use with a plunge router – Not compatible with Rockler 52” to 104” Low Profile Straight Edge Clamp System #36495Out of the box the jig fits straight edge clamp guides from 2-1/4” to 3-1/2” wide provided they have sufficient vertical bearing surfaces. For narrower clamp guides the pre-drilled holes let you mount a spacer block Pre-Drilled for the Following Mid-Size Routers: Bosch 1617Dewalt DW616Dewalt DW618 series – Hitachi M12VC not M12VMakita 1100 series – Porter-Cable 100Porter-Cable 690Porter-Cable 890 series Note: If you plan to use this product with a Skil router please download and use the Drilling Template in the Technical Documents section.