No products in the cart.
33′ 2assembled height. Collapses length: 95Bottom: 2-1/4OD x 18 Gauge x 74Long. 2nd Section: 2OD x 18 Gauge x 80Long. 3rd Section: 1-3/4OD x 18 Gauge x 86Long 4th Section: 1-1/2OD x 18 Gauge x 92″. Long Top: 1-1/4OD x 16 Gauge x 94Long Weight: 45 lbs Features guy rings that rotate and a heavy duty thumbscrew/collar system for setting height Must be guyed or bracketed and installed by an experienced professional. This telescoping mast is made in the USA. It is perfect for mounting antennas for TV Ham Radio WIFI Scanner etc. Contact with a power line can KILL you. Choose a safe installation site. Mast must be guyed approximately every 9′ at the top of each piece of tubing with the distance from the base of the mast to the anchor equal to the height of the mast attachment point. Anchors should be spaced every 120if three guy directions are used or every 90if four guy directions are used. The base and all anchors must be properly grounded. Antenna load should not exceed 2 sq ft of surface area Do not attempt installation or dismantling if there is any wind or on a wet day Tie off mast with rope non metal to deflect away from power line if it should fall during installation or dismantling Use adequate and skilled help in working with this product and have an experience supervisor If you are in doubt as to the proper use or method of installation or dismantling contact an experienced installer and your local electrical utility for assistance.